MENS MONO WATERBOY BLACK/FLURO ORANGE SPEEDO

Regular price $62.00 Save $-62.00

1 in stock

Arena Training Togs - Junior

 Arena Junior Size chart

 Arena Training Togs - Senior

Arena Training adult size

Blueseventy Wetsuits

Blueseventy Wetsuit size

Blueseventy Tri Apparel

Blueseventy Tri sizes

BlueSeventy NeroFit Racing

auto

Engine Training - Male

engine swim sizing

Engine Training - Female

Engine female size chart

 

Funkita Training

Funkita Size

Funky Trunks Training

Funky Trunks Size

 

Orca Gear and Swimware

Orca Gear and swimware

Speedo Training Togs - Female

Speedo size female

Speedo Training Togs - Male

Speedo Male size

SPEEDO COMPETITION SWIMWARE CHARTS

Competition

 

TYR

TYR Swim Chart

TYR Swim Chart 2

TYR race 1

TYR Race 2

Zoggs Training Togs - Junior

Zoggs Youth sizing

Zoggs Training Togs - Adult

Zoggs Ladies sizing

Zoggs Mens sizing

Zone3 Banner

WETSUIT SIZING

GUIDE TO FITTING YOUR NEW WETSUIT

When putting on your wetsuit, undo the zip and crease the suit in half so you can step into the legs of the suit. Pull the suit on using the inside, fabric-side, of the suit to avoid damaging the outside smooth neoprene with your fingernails.  Try instead to use the pads of your fingers. Also avoid rushing to put on as this will get you hot and the suit will be harder to get in to.

The seam on leg of the suit should run of the inside of the leg. The longer end of the leg holes should be aligned to the front and the shorter sides to the back. Be sure you move the neoprene in the legs up towards your crotch. Pull the neoprene in the arms of the suit towards your shoulders. Make sure not to use your fingernails at any point.

Hold the base of the zipper with one hand while using the pull cord to do the zipper up. Be sure the inner zipper panel sits flat underneath the zipper. If possible have someone help you do the zipper up. It is important to push your shoulder blades together so it is easier to pull the zip up.

The suit should fit snugly but not uncomfortably. If the collar feels too tight, be sure the suit is high enough in the hips and have someone help pull the back of the suit up through the zipper towards your shoulders.

When removing the suit undo the zipper before undoing the collar. Make sure you are holding the shoulder or body of the suit when you remove it.

Zone3 Wetsuit sizing

TRI APPAREL SIZING

Zone3 Tri sizing

MENS MONO WATERBOY BLACK/FLURO ORANGE SPEEDO
 
Part of the 'Get Speedo Fit' campaign featuring the Speedo Monogram. This 40cm waterboy has the Speedo monogram detailing along the panels. Made from Endurance, an exclusive Speedo fabric designed to last longer, it is 100% chlorine-resistant to prevent snagging and fading 20 times longer than any other swim fabric. This fabric also features 4 way stretch technology for added softness and comfort.
Available now at Swim T3 - your local swim and triathlon store
 
FEATURES:
Endurance
40cm Side
Internal Drawcord
Contrast Internal Waistband
Plastisol Placement Print
Get Speedo Fit Range
 
COMPOSITION:
50% Polyester
50% Polybutylene
 
ADDITIONAL INFORMATION:
How should I care for my Speedo swimsuit?
 
Pool chemicals and oil residues can be particularly damaging to swimwear containing LYCRA® XTRA LIFE™ fiber. To prevent chemical damage to SPEEDO® swimwear, rinse your SPEEDO® suit in cold water immediately after each use. Do not wash suit with any detergent. Always hang-dry your suit in a well-ventilated space, as mildew will cause premature deterioration of swimwear containing LYCRA® XTRA LIFE™ fiber.
 
Remember that loose fitting garments do not wear as well as those that conform to the body. When putting on your SPEEDO® suit, do not pull too hard on the fabric as it may damage. It is best to pull the suit up onto the body in stages, holding the SPEEDO® suit at the leg openings.
 
MENS MONO WATERBOY BLACK/FLURO ORANGE SPEEDO
MENS MONO WATERBOY BLACK/FLURO ORANGE SPEEDO